Publicidad
Idiomas disponibles
Idiomas disponibles
INCLUDED IN BOX
Base Station
Power Adaptor
Antenna
5 VDC POWER
5 VDC POWER
ETHERNET PORT
ETHERNET PORT
1. Choose a location for the base station that is approximately centered from the target fill stations and relatively free of obstructions. Your base station
will communicate through many types of walls and other structures, but line-of-sight is best. Each base station is designed to cover up to one
typical commercial building floor, but actual construction details will determine how many base stations are needed.
2. Ensure there is Ethernet access available.
3. Ensure that there is a standard wall outlet
4. Ensure that there is a customer account set up on the myEZH2O.com site, and that the base station IDs and fill station IDs have been added
to the customer inventory.
5. Attach the supplied antenna to the connector on the end of the base station.
6. Insert the power plug from the supplied power adapter into the 5 VDC Power connection.
7. Insert the Ethernet cable (not supplied) into the Ethernet port.
8. Plug the power adapter into the wall outlet and observe the LED array. The Power LED will illuminate when the device is correctly powered.
The Process LED will flash while the device is processing information. The Comm LEDs (one or both) will flash while the device is communicating
with the internet. The Radio LED will flash while the device is communicating with the fill stations.
9. Radio strength and other information will be available through the web portal. You may use this information to ensure that there is adequate
communication strength with all of the intended fill stations.
ELKAY MANUFACFTURING COMPANY · 2222CAMDEN COURT · OAK BROOK, IL 60523 · 630.574.8484
1000002101 (Rev. A - 10/14)
REPAIR AND SERVICE INFORMATION—TOLL FREE NUMBER 1.800.260.6640
1000001858
POWER
PROCESS
POWER
PROCESS
LED
LED
LED
LED
RADIO
RADIO
LED
LED
ANTENNA
ANTENNA
Page 2
MOUNTING KEYHOLES
8.500
COMM
COMM
LEDS
LED
Publicidad
