Basic Internet Tv Setup - RCA Powerlink HDP50 Manual Del Usuario

Basic Internet TV Setup

Follow these steps to use the HDP50 Kit with a TV or other home entertainment
device that is Internet-capable.
1
Modem or Router
OUT
2
2. Plug one end of an ethernet cable (not included) into a network out jack
on your modem or router. Plug the other end into the ethernet jack on the
bottom of the HDP50 unit.
3
4
Within moments, the Link indicators on both units should start blinking. If they
are blinking green or orange, your TV or other Internet-capable entertainment
device is now connected to your Internet connection. If the Link indicators blink
red or do not illuminate at all, see the Troubleshooting section in this manual for
possible solutions.
You can use the HDP50 Powerlink Internet Media Kit to connect a
PC to your Internet signal as well. Simply substitute your PC for the
Internet-capable TV or entertainment device in step 4.
The opening of enclosure near AC plug to face up or frontal, the connector face
bottom or rear.
1. Plug one of the HDP50 units
Internet Signal
3. Plug the other HDP50 unit into an
Internet-Capable TV
— OR —
4. Plug one end of a second
Internet-Capable Device
into an electrical outlet near your
modem. The Power indicator
on the front of the adapter
illuminates.
Important: The Powerlink
Internet Media Kit work best when
plugged directly into an electrical
outlet. Do not plug them into a
surge protector, plug strip, or
extension cord.
electrical outlet near your TV or
other home entertainment device
that is Internet-capable. The
Power indicator on the front of
the adapter illuminates.
ethernet cable (not included) into
the network in jack on Internet-
capable entertainment device.
Plug the other end into the
ethernet jack on the bottom of the
HDP50 unit.
3