Publicidad
MAXI-JET POWER HEAD
IMPORTANT SAFEGUARDS
WARNING: To guard against injury, basic safety precautions should be observed, including the following.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
DANGER: To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium
equipment. For each of the following situations, do not attempt repairs by yourself; return the appliance to an authorized
service facility for service or discard the appliance:
1- If the appliance shows any signs of abnormal water leakage, immediately unplug from the power source.
2 - Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended
to be wet.
3 - Do not operate any appliance if it has a damaged cord or plug, or if it is
malfunctioning or has been dropped dropped or damaged in any manner.
4 - To avoid the possibility of the appliance plug or receptacle getting wet, position
aquarium stand and tank to one side of a wall mounted receptacle to prevent water
from dripping onto the receptacle or plug. A "drip loop", shown in the figure, should
be arranged by the user for each cord connecting an aquarium appliance to a recep-
tacle. The "drip loop" is that part of the cord below the level of the receptacle or the
connector, if an extension cord is used, to prevent water travelling along the cord and
coming in contact with the receptacle. If the plug or receptacle does get wet, DON'T
unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the appli-
ance. Then, unplug and examine for presence of water in the receptacle.
5 - Close supervision is necessary when any appliance is used by or near children.
6 - To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp bulbs, and the like.
7 - Always unplug an appliance from an outlet when not in use, before putting on or taking off parts, and before clean-
ing. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
8 - Do not use an appliance for other than intended use. The use of attachments not recommended or sold by the appli-
ance manufacturer may cause an unsafe condition.
9 - Do not install or store the appliance where it will be exposed to the weather or to emperatures below freezing.
10 - Make sure an appliance mounted on a tank is securely installed before operating it.
11 - Read and observe all the important notices on the appliance.
12 - If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than
the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
n°
Description
01
Maxi-Jet Power Head Parts Bag (4-12)
02
Maxi-Jet Power Head Impeller MP-400
03
Maxi-Jet Power Head Impeller MP-600
04
Maxi-Jet Power Head Impeller MP-900
05
Maxi-Jet Power Head Impeller MP-1200
06
Maxi-Jet Power Head Suction Cups (4-12)
07
Maxi-Jet Power Head O'ring (4-12)
Components subject to wear and tear • Componentes sujetos a desgaste • Componentes sujeitos ao desgaste
(fig. 1)
DRIP
LOOP
www.cobaltaquatics.com
803.591.9500
SPARE PARTS
Cod.
MAXI-JET
MAXI-JET
MAXI-JET
MAXI-JET
400
600
900
1200
P0400
P0400
P0400
P0400
P0401
-
-
-
-
PO402
-
-
-
-
P0403
-
-
-
-
PO404
PO405
PO405
PO405
PO405
PO406
PO406
PO406
PO406
7
2
6
AERATION
FEATURE
MULTI-USE SUBMERSIBLE PUMP AND POWER HEAD
POMPE SUBMERSIBLE A USAGE POLYVALENT
BOMBA SUMERGIBLE MULTI USO
MAXI-JET
MODELS
400
600
900
1200
INSTRUCTIONS
AND WARRANTY
MODE D'EMPLOI
ET GARANTIE
INSTRUCCIONES
Y GARANTIA
Publicidad
