Alesis Miclink wireless Guia Del Usuario página 5

Rear Panel
1. Battery Compartment – Insert 2 AAA batteries here
to power the receiver.
2. On/Off Switch – Slide this switch to power the
receiver on.
3. Power Input – Connect the included 5V DC, 1A
Center-Pin Positive adapter power adapter here.
4. Antenna – Place the antenna in a vertical position for
best results in transmitting the wireless signal. If the wireless signal quality
is poor, change the position of the antenna.
Troubleshooting
No signal:
•
Make sure both the transmitter and receiver are powered on.
•
Make sure to keep your hand only on the microphone and keep your hand at least 2 inches (5
cm) away from the transmitter.
•
Make sure you are within the 60-foot (20-meter) transmitting range.
•
Make sure the transmitter and receiver have been paired.
•
Make sure the volume controls on your mixer and speakers are turned up.
•
Check the power LEDs on both the receiver and transmitter. If one of them is off,
device is powered correctly:
Connect the power adapter to (or install fresh AAA batteries in) the receiver.
o
Make sure the transmitter has been charged.
o
Weak signal:
•
Make sure there are no objects (computers, walls, furniture, etc.) between the transmitter and
receiver.
•
Make sure you are within the 60-foot (20-meter) transmitting range.
•
If the receiver is being powered from batteries, install fresh AAA batteries.
Poor signal quality:
•
Keep any connected audio cables away from the receiver's antenna.
•
If the receiver is being powered from batteries, install fresh AAA batteries.
2
3
4
1 5
1
5
3
4
2
check that the