Midea RG57H(B)/BG(C)E Manual Del Usario página 3

Function Buttons
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions section of this manual.
ON/OFF
Turns the unit on or off.
MODE
Scrolls through operation
modes as follows:
AUTO g COOL g DRY g
HEAT g FAN
NOTE：Please do not select
HEAT mode if the machine you
purchased is cooling only type.
Heat mode is not supported by
the cooling only appliance.
ON/OFF
FAN SPEED
Selects fan speeds in
MODE
the following order:
AUTO g LOW g
MED g HIGH
FAN
ION
ION
Press this button, the
Ionizer is energized and
SLEEP SWING
will help to remove pollen
and impurities from the
air.
SLEEP
Saves energy during
sleeping hours.
SWING
Starts and stops louver
movement.
FOLLOW ME
Temperature sensing
and room temperature
display button.
NOTE:
Swing, Ion and Follow me features are optional.
SHORT CUT
Sets and activates your
favorite pre-settings.
TEMP p
Increases temperate in
O
1 C increments.
Max. temperature is
O
30 C .
TEMP q
Decreases temperate in
O
1 C increments.
SHORT
Min. temperature is
CUT
O
17 C .
TIMER
TIMER ON
ON
TEMP
Sets timer to turn unit
TIMER on (see How to Use
OFF
Basic Functions for
instructions)
TIMER OFF
FOLLOW
LED
Sets timer to turn unit
ME
off (see How to Use
Basic Functions for
instructions)
LED
,
Turns indoor unit s LED
display on and off.
If you are sensitive to
light when you go to
sleep, you can press the
LED button to turn off
the LED display on the
unit. Press the button
again to turn it back on.
3
Handling The Remote Controller
NOT SURE WHAT A FUNCTION DOES?
Refer to the How to Use Basic Functions and
How to Use Advanced Functions sections
of this manual for a detailed description of
how to use your air conditioner.
SPECIAL NOTE
Button designs on your unit may differ
slightly from the example shown.
If the indoor unit does not have a particular
,
function, pressing that function s button
on the remote control will have no effect.
When there are wide differences between
, , ,,
Remote controller Illustration and
, , ,,
USER'S MANUAL on function description,
, , ,,
the description of USER'S MANUAL
shall prevail.
Inserting and Replacing Batteries
Your air conditioning unit comes with two AAA
batteries. Put the batteries in the remote control
before use.
1. Slide the back cover from the remote
Control downward, exposing the battery
compartment.
2. Insert the batteries, paying attention to match
up the (+) and (-) ends of the batteries with
the symbols inside the battery compartment.
3. Slide the battery cover back into place.
BATTERY NOTES
For optimum product performance:
Do not mix old and new batteries, or
batteries of different types.
Do not leave batteries in the remote control
,
if you don t plan on using the device for
more than 2 months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted
municipal waste. Refer to local laws for
proper disposal of batteries.
TIPS FOR USING REMOTE CONTROL
The remote control must be used within 8
meters of the unit.
The unit will beep when remote signal is
received.
Curtains, other materials and direct sunlight
can interfere with the infrared signal receiver.
Remove batteries if the remote will not be
used more than 2 months.
4