Linea 2000 DOMO DO158A Manual De Instrucciones página 34

SPEED BUTTON
This button adjusts the ventilation speed. The display will show your selected setting. There are four
settings:
· Low
· Medium
· High
· Silent. You can only select this speed in normal mode. This option is not available for the wind
modes: intelligent, natural, or sleep.
COOLER/HUMIDIFIER
Press the cooler/humidifier button to activate the pump. The associated symbol
display. Make sure the water reservoir contains water before activating this function. The water pump
transports water to the honeycomb filter in generate a cool airflow.
HEATER
Press the heater button to activate this function. The associated symbol appears on the display:
· Press 1 time: low capacity heating
· Press 2 times: high capacity heating
· Press 3 times: turn off heating. Cold air will blow.
Press the mode button to set the temperature. The set temperature flashes on the display. Each press
of the mode button will decrease the temperature by 1 °C. You can also hold the button to change the
temperature setting more quickly. The temperature can be set between 15 °C and 35 °C. When you stop
pressing the mode button, the temperature shown on the display stops flashing and the set temperature
is displayed. You will then see the ambient temperature again.
When the set temperature is reached, the device will stop heating. The symbols disappear from the
display. If the temperature drops 2 degrees under the set temperature, the heating function will activate
again.
Note:
· With this function, you cannot set the ventilation speed.
· If you set a timer, the remaining timer time and ambient temperature will alternate on the display.
· With this function, you can also turn on the humidifier function. There is no chance of dry skin or eyes
while the heater is on.
TIMER
You can set the timer to up to 8 hours. Once the set time has passed, the device will turn off automatically.
Press the timer button. The selected time appears on the display. Keep pressing the timer button until the
desired time appears on the display. Each press bumps the time by 1 hour. When you stop pressing the
timer button, the number on the display will no longer flash and the time is then set.
The remaining timer time and ambient temperature will alternate on the display.
The device will automatically turn off after it has been used for a long time. For safety, the device turns off
after 15 hours of use.
34
DO158A
appears on the