ACME FlyCamOne eco V2 Manual Del Usuario página 6

If necessary, the flat ribbon cable can be unfixed; for this please unlock the detent for one
millimeter (1a/1b) and remove the cable (2). Make sure that the contacts are upturned (as
pictured) while reassembling. The installation of the camera can cause a change of the center
of gravity.
If you want to move the pivot able camera head by a servo (Art.‐No.:AA4120), please remove
the bulge at the inside of the head attachment at first. Then fix the servo arm with the little
screw at the camera head.
The recording modes
The modes will be indicated by different flashes of the LED – the color shows whether the cam
is recording or in stand‐by mode.
video
Serial pictures
photo
To start or stop the recording shortly press the button of your free channel at the transmitter
(switches have to be switched on and off one time). To get into the next mode, keep the
button pressed for 3 seconds.
You can also change the mode manually by pressing the little white button in the corner of the
PCB.
Flip 180°
Keep the button pressed for 10 seconds to flip the picture 180°
The turning will be indicated by the following flash sequence:
red ‐ red ‐ green: regular (cockpit view)
green ‐ green ‐ red: inverse (mounted under the model)
Stand‐By
LED green,
continuous light
LED flashes green,
flashing light 1x/sec
LED flashes green,
slowly flashing light 1x/2sec
www.FlyCamOne.com
Recording
LED red, continuous light
LED flashes red,
flashing light 1x/sec
LED flashes red one time per
recording