WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
GENERAL INFORMATION
The Warm & Serve Drawer can be used:
•
As a stand alone appliance
•
As a combination Warm & Serve Drawer with a 30" (76 cm) built-in oven mounted above
IMPORTANT: The warmer drawer must be installed on a leveled surface from left to right, rear to front.
NOTE: A 60" (152 cm) long cable is supplied with the
Warm & Serve Drawer.
Stand Alone Installation
A. HEIGHT
B. WIDTH
7
9
" (25 cm)
30" (76,2 cm)
/
8
D. CUTOUT
HEIGHT
Min.
8
3
" (21,3 cm) 28
/
8
5
Max. 8
/
" (21,9 cm)
28
8
Warm & Serve Drawer Dimensions
C. DEPTH
5
24
" (62,5 cm)
/
8
E. CUTOUT
F. CUTOUT
WIDTH
DEPTH
1
" (72,4 cm)
24" (61 cm)
/
2
3
/
" (73 cm)
4
IMPORTANT: The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
Combination Warm & Serve Drawer/
30" (76 cm) Built-in Oven Installation
A. HEIGHT
40" (101,5 cm)
30" (76,2 cm)
D. CUTOUT
HEIGHT
Min. 38
1
" (97,8 cm) 28
/
2
Max.
39" (99,1 cm)
9
B. WIDTH
C. DEPTH
5
24
" (62,5 cm)
/
8
E. CUTOUT
F. CUTOUT
WIDTH
DEPTH
1
" (72,4 cm)
24" (61 cm)
/
2
3
28
/
" (73 cm)
4