Transferring Data - Crosscall X-DOCK Manual De Instrucciones

WALL CHARGER CHARGE MODE:
1. Connect the USB jack at the back of the X-Dock to a wall charger
or a computer. The charge status flashes in white while waiting to be
connected to a smartphone.
2. Set your smartphone facing the X-Dock as indicated in the diagram
below (in portrait or landscape mode) as you wish.
3. Your mobile will automatically magnetize and start charging. The
charge status turns to red.
Note: To optimize your smartphone's charge, it is recommended to use a wall
charger that delivers a current of 2.1A and 5V.
It is recommended to fully charge the device to avoid wearing out your
smartphone battery prematurely.
Make sure the charging pad (with the X-LINK connector) is always properly
clipped onto the X-DOCK charging station. If it doesn't start charging, check
to make sure the charging pad isn't slightly out of place.
TRANSFERRING DATA
1. Connect your X-Dock to a computer via the USB jack.
2. Set your smartphone facing the X-Dock (in portrait or landscape
mode) as you wish.
2