Connecting The Display - Optoma Pi500 Manual Del Usuario

English
6
u
Connecting the Display (Figure 7.1)
To setup this display, please refer to the following figure and procedures.
1. Ensure all equipment is switched off.
2. Connect one end of the power adapter to the power connector; plug one
end of the AC power cord into the power adapter, and then the other end
into an electrical outlet (Œ).
3. Connect the VGA signal cable to the 15-pin connector of your host
computer and tighten the screws (•).
4. Connect the Audio-In cable from audio input port of your display to the
Audio-out port of your computer (Ž).
5. Connect the USB signal cable to the USB connector of your host
computer (•).
6. Connect your headphone to the Headphone port(•).
7. Turn on your computer and display.
Notice: To ensure the LCD display will work well with your computer,
please configure the display mode of your graphic card t
less than or equal to 1024 x 768 resolution and make sure timing
of the display mode is compatible with the LCD display.
We have listed the "Compatibility Modes" of this LCD display in
appendices for your reference.