Safety Instructions; Technical Data; Maintenance And Cleaning - Faust DES 180 Manual De Instrucciones

Anleitung DES 180
GB
Please read the operating instructions carefully and
observe the safety regulations at all costs. Keep the
operating instructions together with the triangular
sander.

SAFETY INSTRUCTIONS

Always remove the plug from the socket before doing
any work on the machine (cleaning, changing sanding
paper etc.).
Never remove the plug from the socket by pulling on the
power cable.
For the sake of your health, always wear a dust mask
and goggles when sanding!
Keep the workplace clean and well illuminated.
Before you begin work, make sure the workpiece cannot
slip.
It is in your own interests to keep the machine clean at
all times and to check it for damage after each use.
Make sure the switch is turned to off before connecting
up the machine.
Make sure of your footing, particularly when working on
ladders and scaffolding.
This machine is to be used for dry sanding only.
Always run the cable away from the back of the
machine.
Permanent noise damages your hearing. Wear ear
muffs.
The noise level at the place of work may exceed
85 db(A), in which case ear muffs are required for the
user. The noise generated by this electric tool is
measured in accordance with IEC 59 CO 11, IEC 704,
DIN 45635 Part 21, NFS 31-031 (84/537/EEC).
The processing of asbestos materials is prohibited.
Always check the machine, cable and plug before
starting with your work. Have any damage repaired by a
specialist.

Technical data

Voltage:
Power rating:
Oscillating circle dia.
Oscillations per minute:
Sound pressure level:
Sound power level:
Protection class:
Vibration a :
h
Tool weight:
Sanding paper dimensions:
6
08.11.2001 14:06 Uhr
230 V - 50 Hz
180 W
1.0 mm
6.500
88 db(A)
98.6 dB(A)
8 m/s
1.2 kg
90 x 90 x 90 mm
Seite 6
Putting into operation
Take the sanding paper and place it on the sanding pad.
Make sure that the dust extraction holes coincide. Fix the
sanding paper in position by pressing firmly (with your hand).
Check the mains voltage: The voltage of your power source
must be the same as that specified on the tool's rating plate.
SWITCHING ON/OFF
To switch on, simply move the switch at the bottom of the
tool from 0 to 1.
Replacing the sanding paper
The sanding pad features Velcro-type backing for fast fixing
of the sanding paper without a mechanical clamping device.
Before you attach new sanding paper, remove all dust from
the sanding pad by tapping and cleaning with a brush or
compressed air.
Dust extractor

Maintenance and cleaning

The machine requires no maintenance
Make sure that the ventilation slots are unobstructed and
clean at all times.
Keep the extraction holes in the oscillating plate clean.
If you discover that the machine has a defect in spite of it
having been manufactured and tested with all due care,
have the machine repaired by a specialist.
Notes on working with the machine
The triangular sander is particularly efficient at sanding hard-
to-reach corners and edges. It is possible to work with just
the tip or one edge of the sanding disk when sanding profiles
and flutes. Assorted grades of sanding paper are available
to suit the workpiece material and the depth of surface
removal required. The intensity of sanding depends mainly
on your choice of sanding paper and the controlled pressure
II
you apply to the sanding disk.
2
Environmental protection
Remember that waste prevention is better than waste
disposal.
Dispose of packaging, accessories, defective components
and machines in an environment-friendly manner, i.e.
classify and recycle.
Ask you local council offices for advice.
The dust extractor prevents
serious soiling and high
dust levels in the air your
breathe, and it also makes
it easier to dispose of the
waste dust.