Descargar Imprimir esta página

Bultaco BRINCO Guía Rápida página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Make sure that everything works
correctly before riding your Brinco
1. Seat: adjust the height to your size
2. Handlebar: adjust the height to your size
3. Mechanical Components: make sure
that all items are correctly set (check / see
Torque Table section in User Manual).
4. Brakes: adjust the position of the handles,
check their operation and familiarise
yourself with the brake levers.
5. Suspension: set both the front and rear
suspension as you prefer.
6. Tyres: check their condition and pressure.
Recommended pressure.
Brinco R-Re-C: 1,8bar Front- 2,2bar Rear.
Brinco S: 2,2bar Front - 2,5bar Rear.
7. Throttle lever: handle it carefully and
release it to check that it correctly returns
to its initial position (make sure to do it with
the stop button in the OFF position).
8. Battery: charge it for maximum
performance. Do not forget that when the
battery indicator on the dashboard displays
only two lines, you can use only the eco and
tour ride maps.
9. Side mirror: adjust the position to have a
clear vision (homologated version).
Battery: Removal, charging and reassembling
1. Unplug the power cord
2. Enter the key provided
from the battery by hand
by Bultaco to unlock
by turning the connector
the battery safety lock.
housing a quarter turn
Remove the battery
counterclockwise and
retaining screw.
pulling it out carefully.
INFO
To reassemble your battery, follow the steps described in
reverse order.
If you want to charge your battery without removing
it you must follow only step 1 and directly connect it to the
charger, turning it counterclockwise.
The following charger indicators will show the battery's
charge state:
The battery is charging.
The battery is fully charged.
Failure during charging. Check charger instructions.
To optimize the battery life is recommended to fully charge. We recommend that the BRINCO battery kept
connected to the charger if is not going to be used for more than 30 days. In case you decided not to keep the battery
connected to the charger, make sure to charger the battery for at least 2 hours every 30 days.
GET YOUR BRINCO READY
3. Hold the battery
4. Once the battery is
firmly and rotate it
disconnected from the
slightly on its base to
lower supports, lift the
release it from the upper
battery up to fully remove
chassis anchoring.
it. You can now connect it
to the charger.
WARNING
Before removing the battery make sure your
Brinco is always disconnected. The battery
may be damaged if it is fully discharged.
While charging, place the battery in a safe,
horizontal position, close to the socket.
When you plug the male
connector to the battery,
be sure to align them
properly to avoid damaging
them.

Publicidad

loading