Safety Warnings - TZS First AUSTRIA FA-5680-2 Manual De Instrucciones

NOSE/EAR HAIR TRIMMER
OPERATING INSTRUCTIONS
DEAR CUSTOMER,
Your new trimmer removes unwanted hair from nose and ears quickly and
safely. It has an integrated light so that you never miss a hair. The detail
attachment neatly trims sideburns. The trimmer is splash-proof and is
therefore also suitable for use in bathrooms or other areas in which water is
present. We hope you enjoy using your new trimmer.

SAFETY WARNINGS

This product is equipped with safety features.
Read the safety warnings carefully and only use the product as described in
these instructions to avoid accidental injury or damage.
Keep these instructions for future reference.
If you pass this product on to someone else, remember to include these
instructions.
INTENDED USE
This trimmer set is intended only for the purpose of removing human nose/
ear hairs and for trimming natural beards. It is not for commercial use.
HAZARDS TO CHILDREN
• Do not use the trimmer on children. Keep the unit out of children's reach.
• Disposable and rechargeable batteries can be life-threatening if
swallowed. Therefore, keep battery and trimmer out of children's reach.
If a battery (rechargeable battery) has been swallowed, seek medical
advice immediately.
OTHER CAUSES OF INJURY
• Do not insert the trimmer more than 0.5cm into ear or nostril as you
could injure your eardrum or the mucous membrane in your nose.
• When using the trimmer, make sure the cutting head or detail attachment
is securely fitted.
• The battery should not be touched/changed with damp hands.
• Do not use the appliance on open wounds, laceration, sunburn or
blisters.
• Keep the trimmer away from scalp hair and eyes.
CAUTION - DAMAGE TO THE UNIT
• When cleaning the unit, make sure the battery cover is firmly closed.
• Never immerse the unit in water.
AT A GLANCE (PACKAGE CONTENTS)
1. Protective cap
2. Integrated light
3. Detail attachment for
defining outlines
4. Cutting head
5. ON/OFF switch
6. Battery compartment cover
7. Cleaning brush
8. Stand Base
2
3.
8.
1.
7.
2.
5.
4.
6.
INSERTING BATTERY
1) Before using the appliance, please insert the 1.5V battery (not included),
type LR6/AA, into the battery compartment with the correct polarity.
WARNINGS RELATING TO THE USE OF BATTERIES
• Batteries must be inserted taking care to match the polarities shown.
Make sure that the (+) and (-) terminals are placed in the right direction.
• Never use batteries that show signs of electrolyte leaks or cracking.
• Never dispose of used batteries in an open fire.
• Keep batteries out of reach of children.
• Never recharge disposable batteries.
• Never short circuit battery terminals.
• Always remove used batteries from the appliance case.
• Do not try to open the batteries.
• Do not mix up different kind of batteries or new and already used
batteries together.
• Only use batteries of the recommended or equivalent type.
• Remove batteries from the appliance before disposing of it at the end of
its service life.
2) To insert or change the battery, turn the lower half of the housing and
pull it off downwards. After inserting/changing the battery, replace the
housing.
3) Please make sure that the appliance is properly reassembled before
starting to use it.
USE
NOSE/EAR HAIR TRIMMER:
Remove the protective cap on the trimmer and push the on/off switch
upwards. Now the cutter rotates and you can start trimming hairs in nose
and ear. The integrated light will be helpful.
CLEANING:
Switch the appliance off. For cleaning, turn to remove the Nose/Ear Hair
Trimmer attachment cutting unit and rinse it thoroughly under running water.
Do not wet the appliance unit. The appliance itself should be cleaned with
a dry cloth only.
After complete drying. Replace the cutting units as well as the protective
cap.
BEARD TRIMMER:
Take the nose/ear hair trimmer attachment off the appliance by turning it.
The beard trimmer attachment is also inserted by turning it whist pressing
on the housing at the same time. Make sure, before attaching it, that the
cutting unit points to the right by about a quarter turn so that the two inner
ridges fit properly into the guide grooves on the upper housing.
The beard trimmer is particularly suitable for use on areas that are difficult
to reach and to shorten or shape (smaller) beards.
CLEANING:
Switch the appliance off and remove the beard trimmer attachment from the
appliance by turning it. Remove any hairs left in the cutting head using the
cleaning brush provided then rinse it thoroughly under running water.
3