Cleaning The Filter - Biotech HOME-SPA Manual Del Propietário

CLEANING THE FILTER:

1. Unplug the Main Power Unit from the electrical outlet.
2. Close the water inlet and outlet valve located on the inside wall of the spa by
turning both valves clockwise.
3. Open the Air Purge Valve on the top of the Main Power Unit.
4. Unscrew the Pump / Filter Cover.
5. Lift the Filter Cartridge out of the filter housing. Clean the filter with high
pressure water source.
6. Place the Filter Cartridge back into the filter housing. Make sure the Filter
Cartridge is properly seated in the housing and that the Pump / Filter Cover Seal is
properly seated in the groove.
7. Install the Pump / Filter Cover back on the Main Power Unit.
8. Open the water inlet and outlet valve located on the inside wall of the spa by
turning both valves counter-clockwise.
9. Open the Air Purge Valve on the top of the Main Power Unit.
10. Allow the filter tank to bleed air for approximately one minute, or until water
drips from the fitting. Turn the fitting clockwise to close the bleed valve.
11. Plug the Main Power Unit into the electrical outlet.
12. Turn on filter and heater.
CLEANING THE SPA INTERIOR AND EXTERIOR:
1. You may clean your spa using soap and water or mild detergent.
2. Never use strong cleaning agents.
3. The spa, when clean and dry, can be deflated and stored in a cool, dry area out
of direct sunlight.
4. To deflate, simply open all inflation valves, after draining water.
5. Avoid storing the spa in areas of extreme temperatures and please take
precautions against animals and rodents.
6. Remove and clean the filter twice a month, or more often if necessary. Replace
as needed.
14