Installation And Connection; Set-Up The Unit - Oase SolarSafe 41 Instrucciones De Uso

Ocultar thumbs Ver también para SolarSafe 41:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19

Installation and connection

Set-up the unit

How to proceed:
Place the unit horizontally on the ground ensuring its stable position.
− Do not expose the unit to direct sunlight.
Connect the unit
How to proceed:
B
− Connect the OASE unit with suitable circular connector to the respective connection socket and hand-tighten.
Connection socket
− Two connection sockets. One solar module is connected to each connection socket.
− Power is supplied directly via the solar modules. A sufficient power supply depends on the solar radiation.
− Any excess solar power is used for charging the rechargeable battery.
− Power is supplied directly via the rechargeable battery. This ensures a uniform power supply, independent of the
− A dusk to dawn controller switches the consumer on and off. The dusk to dawn controller automatically determines
− The consumer is turned on at sunset and switched off again after six hours.
− Two hours before sunrise, the consumer is switched on again and is switched off again at dawn.
Start-up
How to proceed:
B
− Remove the protection hood.
− Connect the male and female connectors of the rechargeable battery/charge controller together and ensure that
they properly engage.
The unit is now operational.
Status indicator on the charge controller:
LED
Status
On
Flashes
Off
On
Flashes
Off
On
Flashes
Off
Description
Connection of OASE SolarModule 35
Connection of electrical consumers
Connection of electrical consumers
solar radiation.
Connection of electrical consumers
the sunset and sunrise times.
Description
Charge controller has detected night
Charge controller has detected day
No rechargeable battery connected, rechargeable battery or fuse defective
Connection
Power supply switched off due to deep discharge of the rechargeable battery or overvoltage
Output is switched off due to excessive power consumption
− Max. load current of output is 10 A
Correct operation
Connection
Power supply switched off due to deep discharge of the rechargeable battery or overvoltage
Output is switched off due to excessive power consumption
− Max. load current of output is 10 A
Correct operation
- GB -
9

Publicidad

Tabla de contenido
loading

Tabla de contenido