Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Pull the data logger from the casing.
3.
Replace/Insert the battery into the battery compartment
observing the right polarity. The two displays briefly light
up for control purposes(alternationg, green, yellow,
green).
4.
Slide the data logger back into the casing until it snaps
into place. Now the data logger is ready for programing.
NOTE:
Leaving the model plugged into the USB port for longer than
necessary will cause some of the battery capacity to be lost.
1
WARNING: Handle lithium batteries carefully,
observe warnings on battery casing. Dispose of in
accordance with local regulations.
Sensor Reconditioning
Over time, the internal sensor may be compromised as a result
of pollutants, chemical vapors, and other environmental
conditions which can lead to inaccurate readings. To
recondition the internal sensor, please follow the procedure
www.grupotemper.com
Humidity and Temperature USB Datalogger
2
3
KDL-01
4
7
Publicidad
Tabla de contenido
