System Setup; Hard Drive Assembly - inXtron PD-SATA Super S3 Manual Del Usuario

PD-SATA
2 System Set Up

2.1 Hard Drive Assembly

Your unit may come with a pre-installed hard drive. Before opening your enclosure, please read
the warranty carefully, as this could void it. Be careful not to damage any components when
installing the hard drive!
1. Remove the four screws located at the bottom of the case and pull out the HDD chassis
from the enclosure. It is not necessary to remove the vertical stand for the HDD installation.
2. Install the hard drive and connect both the power and the SATA cable. Mount the drive with
the four screws from the bottom.
[3]
System Set Up