Technical Data - DOL 114 Guía Técnica De Usuario

MOUNTING
Step 1: Loosen the plastic sensor retainer on the radiation shield by
unscrewing two retainer screws.
Step 2: Slide the sensor completely into the radiation shield.
Make sure that the sensor is inserted as far as possible. See
Figure 1.
Step 3: Screw the retainer to the radiation shield until the sensor is
firmly held in place. Do not over tighten the screws.
For Pipe Mounting
Step 4: Remove the U-bolt from the mounting fittings.
Secure the radiation shield to a ¾" to 1½" (Ø 27 mm to 48
Step 5:
mm) iron pipe.
For Surface Mounting
Step 4: Remove the U-bolt and the screw holding the pipe-retaining fittings.
Step 5: Mark the outer two holes of the mounting fittings on the surface.
Step 6: Drill the two holes marked in the previous step into the surface.
Step 7: Attach the radiation shield to the surface.
MAINTENANCE GUIDE
Clean the radiation shield when needed. At least once a year:
Check for damage and miscolouring – replace if necessary.
Step 1:
Step 2: Remove the sensor from the shield.
Step 3: Clean out spider webs, dust and the like.
Step 4: Clean the top of the shield for any droppings from birds.
Step 5: Refit the sensor in the radiation shield.

TECHNICAL DATA

126 mm
220 mm
Figure 5: Dimensions
– TECHNICAL USER GUIDE
dol sensors Agro Food Park 15
130 mm
120 mm
DK-8200 Aarhus N Denmark
Plastic
sensor
retainer
Sensor Retainer
Sensor diameters
10.2 mm - 12.44 mm
(0.40" - 0.49")
Figure 4: Optional two sided sensor retainer
This two-sided sensor retainer can be used for varying
sensor diameters depending on which side of the retainer is
being used.
PRODUCT SURVEY
140245 Radiation Shield
140200 DOL 12 with 1.4 m cable
S140200A DOL 12 with 5 m cable
140252 DOL 114 with 2 m cable
140253 DOL 114 with 5 m cable
Tlf. +45 72 17 58 88 Fax +45 72 17 59 59
U-bolt
Figure 3
Sensor diameters
12.7 mm - 17.5 mm
(0.50" - 0.69")
www.dol-sensors.com