Troubleshooting; Error Codes - Danby DAP290BAW Manual Del Propietário

TROUBLESHOOTING

PROBLEM
Appliance will not operate
Insuffi cient air purifi cation
Appliance will not resume
functioning after cleaning the fi lter
Odors

ERROR CODES

E1 - fi lter installation error
• check that all air fi lters are correctly installed
E0 - hardware fault
Eu - sensor fault
E3 - fan speed fault
If the codes E0, Eu or E3 appear on the display,
unplug the air purifi er and allow it to sit undisturbed
for 5 minutes. If the error code persists when the air
purifi er is plugged in, please contact a local service
depot.
POSSIBLE CAUSE
• Plug is not fully inserted into the wall outlet
• Blown fuse or circuit breaker
• The fi lter may not be correctly installed
• Air fi lter is dirty or needs to be replaced
• Blocked air fl ow
• Appliance size is too small for application
• Ensure that all packaging has been removed from
the fi lter
• Press and hold the PM2.5 button for 3 seconds to
reset the fi lter
• Replace the air fi lter
DISPOSAL
This appliance should not be treated as regular
household waste. Check for local regulatory
compliance regarding the approved and safe
disposal of this appliance.
7