Nagel FOLDNAK M2 Manual Del Usuario página 12

Troubleshooting
Machine is switched on, but the light inside the ON/OFF-Selector (7) is not on
The power cord is plugged in improperly: Push power cord thoroughly into power
Circuit braker has been activated:
Internal problem:
Button „START" (6) is being pushed, but machine does not work
Cover (5) is open:
Staple jam inside staple channel:
Jam of the moving parts because too
much paper has been inserted:
Circuit braker has been activated:
Internal problem:
Machine does not staple although the staple magazine is filled
Driver blade (16) is not hinged onto pin
(17):
Driver blade (16) is missing:
Staple jam inside staple magazine:
Staple pusher (12) does not push staples: Push staple pusher gently down to unlock
Staple jam inside staple channel:
outlet.
Push circuit braker button in again. It is
located at the machine's rear, beneath the
power cord outlet.
Contact your dealer.
Close cover.
Take off stapling head, remove both
screws of front plate (18), take off front
plate. Remove jammed staple, clean stap-
le channel and reassemble.
Push button „RESET" (9) for a few sec-
onds. The machine then runs backwards,
enabling the operator to pull out jammed
paper.
Push circuit braker button in again. It is
located at the machine's rear, beneath the
power cord outlet.
Contact your dealer.
Hinge hole of the driver blade (16) onto
pin (17).
Put in a driver blade. The mark „26" must
show towards the rear side of the ma-
chine.
Use original NAGEL-Staples and make
sure to only use types 26/6 or Ri 26/6.
and guide it towards the staples.
Take off stapling head, remove both
screws of front plate (18), take off front
plate. Remove jammed staple, clean sta-
ple channel and reassemble. Use only ori-
ginal NAGEL-Staples and make sure to
only use types 26/6 or Ri 26/6.
12