KLASS Fan Wall-Wifi Instrucciones De Funcionamiento página 12

PAIR YOUR REMOTE
When you connect your fan to the network for the first 30 seconds, a pairing
channel is opened.
To pair your fan, press and hold the power key for 5 seconds in the 30 second
period.
The fan responds with a long beep. Your fan is now paired.
Notes:
- Transmitter does not pair: Your transmitter is too far from the receiver. There is
another transmitter within range of your receiver.
- If you notice swift light flash, it is because you have not correctly connected the
earth.
OPERATION
Your fan is equipped with memory function. This allows more convenient operation
with the switch.
When you leave the room, if you turn off your fan with the switch, the latter will
memorize the last programmed mode.
Example: you go out of the room with the light on, ventilation in Speed 2, you
switch off the fan with the switch. When you return, using the switch, your fan will
turn on the light, and set the fan to Speed 2.
The memory function memorizes the following modes: light, direction of rotation,
speed of rotation.
1. Fan ON/OFF: Press to switch on/off the fan.
2. Temperature / WiFi :
Temperature: The control receiver has a thermostat to automate the change of
speed according to the temperature under the fan.
Press the temperature button to switch the fan to temperature mode.
In this pre-programmed mode, your fan will react as follows:
Temperature
Speed
In winter mode, it has the same operation but the blades turn in the opposite
direction.
WiFi: Press the "Temp." button for 5 seconds to enter the WiFi function, the fan
will beep continuously until the device is in the network (see the "WiFi APP" section
for configuration).
3. Light ON/OFF: Press to turn on / off the light.
Selection of colors of the light: RGB mode or Tone (3000/4000/6000 KV)
depending on the model.
4. Timer: Press to select the operating time until it turns off.
0 ~ 19° 19° ~ 21°
1 2
22° ~ 24° 25° ~ 26° 27 ~ 28°
3 4
10
+29°
5 6