resideo WHLDT Manual De Instrucciones

Water Leak Alert
WHLDT
READ BEFORE INSTALLING
INTRODUCTION
Congratulations on your purchase of the Resideo Water Leak
Alert. The Water Leak Alert takes water sensing to a new level
of reliability. This product is unique because it uses a
patented water sensing cable that can be wrapped in a
variety of locations around your home to detect water and
alert you to its presence before it becomes a bigger issue.
This product provides 16x more coverage than traditional
water alarms with "spot" detection and is one of the most
versatile water sensing product available! Place throughout
your home wherever you would like the peace of mind of
sensing water leaks.
Resideo Water Leak Alert can be easily mounted on self-
powered water heaters and can be connected to a Resideo
gas valve. When connected to a Resideo gas valve, you get
the added benefit of turning the water heater off
automatically when a leak is detected.
Preparation
1. Remove the battery cover on the front of the unit by
pushing the latch on top. Then insert 2 AA batteries and
replace the cover.
(2xAA 1.5 V)
TE ST
Fig. 1. Insert batteries.
2. Insert the cable plug into the jack on the bottom of the
leak detector. See Fig. 1.
Installation: Leak Alert Only
1. Place the leak detector so the cable is positioned where
leaks are likely to occur. This is usually on the bottom
level of a building, near water sources, or anywhere
leaks are possible.
2. Arrange the leak sensing cable so it is in position to
detect leaks.
3. Use double-stick tape to attach the back of the leak
detector to a wall or other flat, dry surface.
Installation: Leak Alert and Self
Powered Water Heater Shutoff
(ONLY FOR RESIDEO SELF-POWERED GAS WATER HEATER
CONTROL)
1. Turn knob to off position. Remove the thermopile con-
nectors from the Resideo water heater controller. See
Fig. 2.
Fig. 2. Remove thermopile connectors.
M36674A
OWNER'S GUIDE
M36675A
34-00023EFS-07