Replacing The Fuse - Chauvet Professional Amhaze Studio Guía De Referencia Rápida

Amhaze™ Studio QRG
Contact
What Is
Included
AC Power
AC Plug

Replacing The Fuse

DMX Linking
DMX Connection
Preparing for
Operation
Fluid Tank Indicator
Lights
·
From outside the U.S., UK, Ireland, or Mexico, contact the distributor of
record to request support or return a product.
·
From inside the U.S., UK, Ireland, Mexico, or Benelux, use the information in
Contact Us at the end of this QRG.
·
Amhaze™ Studio
·
Neutrik® powerCON®
power cord
This product has a fixed voltage power supply and it can work with an input
voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific
model.
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the
housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Amhaze™ Studio will work with a DMX controller using a 3- or 5-pin DMX
serial connection.
www.chauvetprofessional.com.
The Amhaze™ Studio uses a 3- or 5-pin DMX data connection for its 2-channel
DMX personality. See the User Manual for information about connecting and
configuring the product for DMX operation.
To prepare the Amhaze™ Studio for operation:
1. Open the flight case.
2. Pull out the fluid tank and remove the cap.
3. Verify that the two plastic hoses attached to the cap are in place and in good
condition.
4. Pour CHAUVET® (PHF or HFG) haze fluid inside the tank, and re-cap.
5. Reinsert the tank.
6. Make sure that the plastic hose that goes from the cap to the hazer is not bent.
7. Plug in power and wait approx. 2 min. for warm-up to complete.
Three internal indicator LEDs show the status of the fluid tank, as follows.
·
Red - the fluid tank is currently heating up
·
Blue - the fluid tank is ready
·
Flashing Red/Blue - the fluid tank is actively re-heating while producing
output.
Only use CHAUVET® approved (PHF or HFG) haze fluid. Otherwise, you
might not have satisfactory results. In addition, unapproved fluid can damage
the Amhaze™ Studio or cause harm to humans or animals.
·
·
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
A DMX Primer
3
Warranty Card
Quick Reference Guide
Screw Color
Brown Yellow/Brass
Blue
is available
EN
Silver
Green
from