Tabla de contenido
Publicidad
Start Building
1
To begin your model, find the
and follow the
numbers. Each piece has its own shape and color. Just
look at the pictures, find the pieces in your set that match
and then connect them together. Try to face your model in
the same direction as the instructions while you build.
The arrows show you where the parts connect, but not all
connections points have arrows.
1
2
3
-
1
2
F F C C C C S S t t a a t t e e m m e e n n t t s s : :
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for the compliance could void the users right to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may cause
undesired operation. This model is tested to comply with FCC standards - FOR HOME OR
OFFICE USE.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: (1) Reorient or relocate the
receiving antenna. (2) Increase the separation between the equipment and receiver.
(3) Consult the dealer or an experienced radio/TV technician. (4) Connect the equipment
into an outlet on a circuit different from that to which the receiver is connected.
This Class B digital apparatus complies with Canadian ICES-003.
BUILDING BASICS
Track
Always connect the track top side to top side throughout
the build. Be sure to push the connectors on firmly until
they "click".
Motor
Car will go in the direction of the arrows on top of the motor. Always wait a few seconds
after turning the motor on before gently pushing the car towards the motor.
Connectors
There are blue and gray connectors with special long slots.
They slide together as you see in the pictures. Push these
parts together until you hear a "click."
Parts Count
Before you start building, be sure to compare the parts in your set
with the parts list here. If anything is missing, call or write to us
using the information on the back cover. We are here to help you!
3
Publicidad
Tabla de contenido
