Installing Or Uninstalling The Widcomm Bluetooth Stack; Installing The Widcomm Bluetooth Stack - RocketFish RF-BTCMBO Guía De Usuario

3
Replace the battery cover.

Installing or uninstalling the WIDCOMM Bluetooth stack

Installing the WIDCOMM Bluetooth stack

To install the WIDCOMM Bluetooth stack:
1
Plug the USB Bluetooth dongle into a USB port on your computer.
2
Insert the provided installation CD in the CD or DVD drive. The
installation stack loads automatically.
Note: If the installation stack does not load automatically, double-click Setup.exe in
the bin folder of the installation CD.
The Welcome Screen introduces you to the installation process.
3
Follow the on-screen prompts to complete the WIDCOMM Bluetooth
Software wizard.
Note: If the "Bluetooth device not found" message appears, plug the USB Bluetooth
dongle into a USB port on your computer, then click OK. The Found New Hardware
Wizard starts installing the components for the USB Bluetooth dongle.
4
After the wizard finishes, remove the dongle and plug it back in. The
keyboard and mouse pair automatically.
5
Click Finish to exit the installation.
6
In Windows 2000, a prompt requires you to restart the computer so that
the Bluetooth stack takes effect. Click Yes to restart your computer now
or No to restart later.
12