Kenmore 148.16156211 Manual De Uso Y Cuidado página 9

5. If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes for gas to clear away, and repeat
the lighting procedure.
6. To light other burners, repeat step 4.
NOTE: If ignitor does not work, follow Match Lighting
instructions.
Turn controls and gas source or tank OFF when
not in use.
Please make sure the drip tray and drip cup are
properly installed when burners are on.
Drip tray is hot when burner is on and after grilling.
Do not touch the drip tray when it is hot.
If ignition does not occur in 5 seconds, turn the burner
control off, wait 5 minutes, and repeat the lighting
If the burner does not ignite with
procedure.
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of
injury.
Match-Lighting
Do not lean over grill while lighting.
1. Open lid during lighting.
2. Place match into match holder (hanging from side of cart).
Light match, place into the firebox.
3. Push in and turn right knob to HIGH position. Be sure burner
lights and stays lit.
4. Light other burners by pushing knob in and turning to HI
position.
Sideburner Match Lighting
1. Open sideburner lid. Turn on gas at LP cylinder.
2. Place lit match near burner.
3.Turn sideburner knob to HI. Be sure burner lights and
stays lit.
Burner Flame Check
•Remove cooking grates and heat diffusers. Light burners,
rotate knobs from HIGH to LOW. You should see a smaller
flame in LOW position than seen on HIGH. Perform burner
flame check on sideburner, also. Always check flame prior to
each use.
Turning Grill Off
•Turn all knobs to position. Turn LP cylinder off by turning
hand-wheel clockwise to a full stop.
Ignitor Check
•Turn gas off at LP cylinder. Push the control knob in and
turn the knob to the left to "HI" position."Click" should be
heard and spark seen each time between collector box or
burner and electrode. See "Troubleshooting" if no click or
spark.
Valve Check
•Important: Make sure gas is off at LP cylinder before
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn back
to OFF position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only identical
replacement part valve/hose/regulator as specified in the
Parts List of this Use and Care Guide.
General Grill Cleaning
•Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong
solution of detergent and water or use a grill cleaner with
scrub brush on insides of grill lid and bottom. Rinse and allow
to completely air dry. Do not apply a caustic grill/oven
cleaner to painted surfaces.
• Plastic parts: Wash with warm soapy water and wipe dry.
9