Product Overview - Transmitter - C2G C2G30012 Manual De Instrucciones

HDMI® HDB T + VGA, 3.5
ASE
T B R
RANSMITTER TO OX
P O
RODUCT VERVIEW
F P
RONT ANEL
1
2
F P D
RONT ANEL ESCRIPTION
Connect to a VGA and audio source using a VGA and 3.5mm
1 VGA with AUDIO IN
audio cable.
2 HDMI IN Connect to an HDMI source using an HDMI cable.
3/4 VGA / HDMI LED One light will be on, indicating which input is selected.
On: HDCP protected content is being transmitted.
5 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
6 Link LED
Off/Blinking: No HDBT link or link error.
On: Power is applied to the device.
7 Power LED
Off: No power is applied to the device.
, USB-A
MM AND
- 4K 60H
ECEIVER Z
3 5
7
4
6
Transmitter
8
9
10
11
12
B C E
TO OVER AT XTENDER
R P
EAR ANEL
8 INPUT Button
9 DISPLAY Button
10 AUDIO IN
11 USB-B Host Port
12 USB Micro-B IN
R P
EAR ANEL
13 HDBT OUT
14 Power
2
W P
ALL LATE
Short press: Switch input source.
Short press: Turn display on (CEC).
Long press: 3 seconds to turn off display (CEC).
Connect one-way analog audio pass through from wall-plate
transmitter to receiver.
Supports USB 2.0 pass through over HDBT.
Supports firmware updates through this port.
D
ESCRIPTION
Connect to the receiver via a Cat 5e/6/6a cable.
2-pin phoenix connector for local DC 12V input .
( )
US
Transmitter
13
14