Prince Castle 411-SD Serie Manual Del Usuario página 7

Tabla de contenido

Publicidad

displayed, press the temperature button to store
the new setting. See figure 8.
3. To cancel the set point programming mode at any
time, press and release the time button. The
figure 9
display will change to show the actual platen
temperature. See figure 9.
Programming Toast Times
1. Press and hold the time button for 6 seconds. A
beep will sound, and the time indicator light will
figure 10
blink. Release the time button to show the
current toast time. See figure 10.
2. Use the up and down arrow buttons to set your
desired toast time. The range is from 20 sec-
onds to 1 minute, 30 seconds. When desired
figure 11
SETTING THE NEW TIME
STORING THE NEW TIME
2000 McDonald's Corporation
All Rights Reserved
2 1 5
5 5
3 5
3 5
Part No. 411-543 Rev C
time is reached, press and release the time
button to store the new time. See figure 11.
3. To cancel the time set function at any time, press
and release the temperature button. The time indica-
tor light will turn off, and the display will change to
figure 12
show the actual platen temperature. See figure 12.
SETTING STOP BLOCKS
Stop blocks allow for proper crush when toasting
buns. The toaster leaves the factory with the stop
blocks set on R/Q.
Dual stop blocks allow you to switch back and forth
from Reg/Qtr. bun and Big Mac Bun toasting, or Rib
bun or Rye bun toasting.
1. Ensure the stop blocks are on the correct setting.
There are (6) combination Stop Block Settings:
1. R/Q / MAC
2. R/Q+ / MAC +
3. R/Q- / MAC -
THE (+) SETTING IS FOR BUNS THAT ARE CUT
TOO THICK. THE (-) SETTING IS FOR BUNS CUT
TOO THIN. FOR NORMAL SIZE BUNS DO NOT
USE (+) or (-) SETTINGS.
[R/Q = REG/QTR]
2. Rotate stop blocks by hand to the desired
combination bun setting listed above.
3. View the stop block setting selected through the
index window bracket, which is located over the
figure 13
SIDE PANEL
INDEX WINDOW BRACKET
7
2 1 5
4. RIB / RYE
5. RIB+ / RYE +
6. RIB- / RYE -
STOP BLOCK
BUN SETTING
(REGULAR BUNS)
Printed in the
United States of America

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido