Using The Dms80'S Line Outs - Samson Audio RESOLV 120a Instrucciones De Seguridad

Connecting the RESOLV 120a
USING THE RESOLV 120A WITH THE SAMSON DMS80 MONITOR SYSTEM

Using The DMS80's LINE OUTs

The RESOLV 120a can be connected to the DMS80 by using the LINE OUTS located on the DMS80's rear panel. When
using the DMS80's LINE outputs you will utilize the RESOLV 120a internal electronic crossover, which will allow you
to experiment and fine-tune your monitor system. Follow the diagram and instructions below to interface your new
subwoofer.
– +
INPUT
• Make the connections between your mixer and your DMS80 monitor system as described in the DMS80's users man-
ual and make sure that you turn your mixer all the way down.
• Connect the RIGHT and LEFT LINE OUTPUTS located on the rear panel of the DMS80 to the RIGHT and LEFT PREAMP
INPUTS on the RESOLV 120a.
• Turn the RESOLV 120a's Volume all the way off, and set the SWEEP control to 100Hz.
• Now run some audio, like music on a CD, through your mixer and raise the output to the DMS80 monitor system to a
comfortable listening level.
• Now, slowly raise the RESOLV 120a's LEVEL control and adjust the low frequency output to your taste. You can exper-
iment by listening to the difference when adjusting the crossover point with the SWEEP control. Also, listen as you
adjust the balance between the RESOLV 120a and the DMS satellite speakers by changing the RESOLV 120a's LEVEL
control. Once you find the balance you like, the RESOLV 120a will track the satellites when you raise or lower your
mixer's output.
+
–
SPEAKER OUTPUTS SPEAKER IMPEDANCE 4-8 LINE IN AUX IN LINE OUT
LEFT RIGHT LEFT RIGHT LEFT
LEFT+ LEFT- RIGHT- RIGHT+
SAMSON
DESKTOP MONITOR SYSTEM STEREO 40W X2 MODEL:DA80
10 Inch Long Throw Transducer 120 Watt Amplifier
18
SUB OUT
RIGHT MONO
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE
AVIS
RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRIR
CAUTION
FOR CONTINUED PROTECTION AGAINST RISK
OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE
ATTENTION
UTILISER UN FUSIBLE DE
RECHANGE DE MÊME TYPE
SERIAL
–
NUMBER MADE IN CHINA
+
– +
INPUT