Feiss Jonah 8 Light Island Instrucciones De Instalación

Installation Instructions for
Jonah 8 Light Island
Chandelier
G ENERAL RODUCT NFORMATION P
These fixtures are intended to be installed utilizing
junction boxes.
This product is safety listed for damp locations.
1A
3
5
HEX NUT
WASHERS
FIXTURE
SCREW
14
SWIVEL
8
STEM
6
1 Temporarily install the mounting plate to the junction box.
Mark the anchor locations through the holes on the mounting plate, then remove the mounting plate.
2
Install the anchors to the marked points.
3
Secure the mounting plate to the junction box.
4
Screw the anchor screws into the anchors.
5
6 Determine the height of the fixture with the provided stems and assemble them by screwing them together.
Feed the cord through the stem assembly and screw the stem assemblies to the fixture.
7
Feed the cord through the swivels and screw them to the stem assemblies.
8
Secure the swivels to the canopy and canopy plate with the provided nuts and washers.
9
10 Pull the power line wires out of the junction box. Trim the cord leaving enough to make electrical connections.
11 Connect the fixture to a suitable ground in accordance with local electrical codes.
12 Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
13
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place with the
14
fixture screws.
15 Using a cloth, install the lamp by inserting the lamp pins into the socket. Refer to the label on the lamp socket for Max
Wattage information.
Install the lamp shield over the lamp.
16
Place the inner shade into the shade base, then place the outer shade over the inner shade and into the shade base.
17
Repeat steps 15-17 for remaining sockets.
I :
NEC compliant
ANCHOR
12 13
MOUNTING PLATE
ANCHOR SCREW
8
CANOPY PLATE
14
CANOPY
8
LAMP SHIELD
SOCKET
6
SHADE BASE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
OUTER SHADE
17
16
LAMP
15
1
CAUTION RISK OF FIRE -
INNER SHADE
7 7
F2986-8
F2986/8
1.0