How To Operate - Nostalgia Products LPF150 Instrucciones Y Recetas

HOW TO OPERATE

1. Wipe out the Beverage Bowl with a damp, non-abrasive cloth and dry. Wash Crown Topper,
Rods, Tier Bowls, Extension Spouts and Pump in warm, soapy water, rinse then dry.
2. After cleaning the unit, assemble the LIGHTED PARTY FOUNTAIN. Make sure the parts
are fitted together tightly and the fountain feels sturdy and is properly aligned.
3. Find a stable surface near an electrical outlet. Unit must be level to operate
properly and to create the desired flowing effect. Make sure your cord is away
from any water source. If needed, it is acceptable to use an extension cord.
4. Add beverage (LIGHTED PARTY FOUNTAIN holds 96 ounces of liquid) and fill to
the line on the inside of the Beverage Bowl. DO NOT fill above the line.
5. Plug unit in and turn on by flipping the toggle switch on the Lighted Base.
6. The liquid will begin to rise up the Rods, filter through the Tier Bowls and trickle out of the
Extension Spouts. At this time, adjust the Tier Bowls and Extension Spouts to desired flow.
7. Cups can be filled by holding them under the Extension Spouts as the beverage trickles out.
8. As the beverage level decreases, refill the Beverage Bowl and keep it at the maximum
fill level for best results. Make sure that unit is turned OFF before adding liquid.
9. The LIGHTED PARTY FOUNTAIN must remain level to ensure proper flow of beverage. Be
careful not to drop pieces of food into the Beverage Bowl. This would clog the flow of liquid.
6