Product Structure; Operating Procedures - SPORT ELEC ISTITUT KW-005 Manual Del Usuario

Anion Aroma Diffuser
The Anion Aroma Diffuser is an innovative product that
combines the best of East and West technology, science
and culture. By adopting the advanced ultrasonic
technology, the Anion Aroma Diffuser can break up the
essential oil and water into extremely fine micro-particles
and releases the active ingredients and anions into the
air.
This natural aroma therapy technique will create a
soothing, calming atmosphere. The water vapour that
released in the air also acts as a natural moisturizer for
our skin.
This technology does not use heat that can destroy some
properties in the essential oil and the micro-particles re-
main in the air longer and can be absorbed into our
body easily for better therapeutic effect.
Note:
With several drops of soothing essential oil, this
product is great beneficial and helpful for you to enjoy
sleeping all night long. It's an ideal appliance for the li-
ving room and the bedroom.
Precautions
Please read the precautions carefully before use.
After reading, please keep this manual in a safe place
for easy search and future reference.
- Continual use this product under abnormal situations
such as smoke, abnormal smell or sound may result in
accidents such as fire and electric shock. Unplug the AC
adapter immediately in the case of smoke,
abnormal sound and smell coming out of the unit. DO
NOT try to repair the unit but contact your local dealer
for servicing.
- Never wrap the AC adapter with cloth or paper. Other-
wise the heat can not be dissipated properly, which may
result in deformation and fire.
- Never touch the AC adapter with wet hands. Other-
wise electric shock and personal injury may occur.
- This product is not suitable to be used by children and
should be kept out of their reach.
- During operation, never take out the water tank or add
any foreign matter into the water reservoir.
- Do not place your finger onto the cerami disc of the
reservoir.
- Do not put chemical such as acid, alkal etc. into the
water reservoir.
Otherwise it may damage the machine or shorten its li-
fespan.
- Only use the AC adapter supplied with this machine.
- To ensure safety, please pull out the AC adapter from
the outlet when the machine is not used. Please pull out
the AC adapter from the outlet before the machine being
repaired or maintained.
- Do not operate the machine if the adapter is found
loose after being plugged.
- Do not use corrosive detergent or strong solvent to
clean the machine

PRODUCT STRUCTURE

(Picture A page 1) :
1. Atomization Port
2. Water Tank
3. Light
4. Ceramic Disc
5. Water Level Sensor
6. Watre Level Line
7. Water Reservoir (Picture B page 1) :
8. Cover
9. Socket :
10. Remote Control (Optional)
11. AC Adapter (Picture C page 1)
12. Spout (Picture D p.1)

OPERATING PROCEDURES

1. Take out the water tank (see picture 1, page 2)
2. Fill the water tank with tap water and then close up
the knob, then wipe up exterior of the tank.
(see picture 2, page 2)
3. Replace the water tank. (see picture 3, page 2)
A) Place water tank handle opposite the light, and then
tighten it downwards.
B )Please, wipe off the water on and below the water
tank.
4. To obtain the longest atomizing cycle, make sure that
both water tank and reservoir is fully filled.
(see picture 4, page 2)
You are suggested to repeat step 2 and step 3 twice to
make sure both the water tank and the water reservoir
is in full-filled condition.
5. Water filling should not exceed the water level
inside the water reservoir. (see picture 5, page 2)
Tips for filling water reservoir
- Tips for completing the water reservoir:
Use spout such as a cup to fill the water reservoir first,
then fill the water tank and place it back to the unit as
shown in picture 3.
6. Plug the power and press the "ON" button.
(see picture 6, page 2)
Note: Do not lean the machine or place the
unit on an uneven surface while there is water
inside
7. How to add essential oil. (see picture 7, page 2)
or depurative water.
-5-
- Press "OFF" button and then take out the water tank.
- Add 2-3 drops drops of your favourite essential oil into
the water reservoir.
- Replace the water tank and turn on the power to enjoy
the wonderful fragrance of the essential oil.
8. Operating Modes for selection.
(see picture 8, page 2)
This aroma diffuser has two kinds of operating modes
for selection.
- Continuous-operating mode:
Press "ON" button, the product will be in
continuous-operating mode with light turns up. Press
"ON" button again if the light needs to be turned off.
- Interval-operating mode:
Press "30SEC" button, the product will be in mode of
"30-second operating/30-second idle, intermittently"
with the light turns on. Press "30SEC" button again (see
picture 8, page 2) if the light needs to be turned off.
MAINTAINANCE
1. Press "OFF" button and unplug the power. (see
picture 9, page 2)
2. Take out the water tank. (see picture 10, page 2)
3. Empty the reservoir. (Lean the product as illustrated
and then pour water from the side of the unit.)
(see picture 11, page 2)
It is prohibited to pour water from top of the
Specification:
Product name : Aroma Diffuseur
Ref.: KW-005
Rated Voltage: 24V
Power: 13,5 W
Mist Volume: 25 ml/hr
Remote Controlling Scope: 8meters (P.S.: Only for product with remote control)
Dimensions : Ø11 x 30 (h) cm
Net Weight : 0.740Kg
TROUBLESHOOTING :
Problem
There is no mist
US
unit. (see the picture)
4. Clean. (see picture 12, page 2)
- Use a cotton swab to rub the atomizer softly.
- Use soft cloth to clean exterior of the machine.
- You are suggested to clean the machine once or twice
per month.
NOTES
- This product is suggested to use tap water for better
atomizing effect. It's not suitable to apply distilled water
or depurative water.
- In case of careless dumpage occurs during operation
and leads water into interior of the unit, unplug the
power immediately and empty the water inside, then lay
the unit in ventilated place for about 3 days to make
sure it's naturally air dried before reuse.
Should any abnormity or malfunction arise
during reuse, please contact your local dealer.
Please apply regulations enforced in your country when
disposing your product at its end of life. Therefore, please
discard it in a location planned to this effect, ensuring it is
disposed in an environment-friendly manner
Cause
The power cord is not connected Plug the power and switch on the
properly machine
There is insufficient water left in the Refill the water tank and turn it on again
reservoir
There is too much water that exceeds the Reduce the water level till below the water
water level line level line
The atomization port is blocked by water Eliminate or remove the impediment
film or other objects
The ceramic disc is aging after running for Please contact your local dealer.
approx. 3000 hours
-6-
Solution
US