Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
V Removing the Housing for Assembly
and Servicing
Apart from servicing and change of the input
voltage (focus and zoom), it is sometimes
necessary to remove the lens housing, e.g. when
installung the camera/lens combination in a
weatherproof housing. For the series
G06Z12NDDC(Po) proceed as follows:
a) Disconnect the lens from all the power.
b) Unscrew the holding screws on each side
c) After unscrewing the holding screws remove
the housing cover.
To reassemble use the sequence as described
above is reversed.
50
101,5
128
Housing
fixing
screws
1/4" – 20
10
12
82
Dimensions: mm
Publicidad
Tabla de contenido
