GINGKO clickclock radio Manual Del Usuario página 5

to search for your preferred channel. When you are finished tuning press the aluminium
button once to exit manual tuning mode
●
You may need to gently pull out the antenna located at the back of the radio for a
better connection. When you see red on the antenna this indicates that you should not
pull any longer.
VOUME CONTROL OPERATION
● Turning the aluminium button clockwise or anti-clockwise will turn up or turn down the
volume of the Radio - the volume numbers (between 00 and 10) will appear in replace
of the frequency when you do but it will return back to frequency display in 3 seconds if
no further volume operation has been detected.
● 00 stands for the lowest volume (mute) and 10 stands for the highest volume.
SNOOZE FUNCTION INSTRUCTIONS
● press the aluminium button once to snooze and twice to stop.
● When the alarm goes off with buzzer sound, it will ring for 1 minute before it
automatically goes to snooze
● When the alarm goes off with Radio, it will play for 10 minutes before it automatically
goes to snooze.
● there are 5 minutes between each snooze interval
●
The clock can be snoozed for 5 times in total and then it will stop.
IMPORTANT PRODUCT CARE INFORMATION
● This product is made from wood. Please keep in a dry place and if needed clean with a
soft dampened cloth
● Please only use the adapter supplied with the clock to power this product; If any other
adapter with the wrong rated output is used on this clock, it may damage this clock and
this will not be covered by the manufacturer warranty.
●
Place this item in a safe place and keep away from high heat or wet areas. Heavy knocks
or falls may seriously damage this product.
●
When the display number/numbers start flashing, it means the battery is low, not a
fault. You will need to recharge it as soon as possible to solve this issue.