Do not use, connect or disconnect the device to the network with wet hands and/or feet.
- Do not wrap the cord around the control button.
- This IPX1 device has been designed so that it can be used in any room, including those where there is a risk
of splashes from above such as the bathroom, kitchen, etc. However, both the electrical installation of the
product and how it is used must comply with current safety standards in the country.
B&B TRENDS SL accepts no liability for any damage that may be caused to people, animals or objects owing
to failure to observe this warning correctly.
INSTALLATION
Install in accordance with the current safety standards in the country.
1. Place the device on a hard, rigid, fl at, stable horizontal surface free of vibration.
2. Keep any combustible material away from the product, whether furniture, clothing, paper, curtains, etc.
Keep them at least 50cm away from the device. It is recommended that the air inlet and outlet of the
device is free of objects: at least 1 meter off the air and 50cm from the air inlet behind the appliance.
3. Never place above a bathtub if the device is placed in a bathroom. Keep at least a distance greater than
60cm to prevent splashes as shown in Fig.
INSTRUCTIONS FOR USE
The safety instructions marked at the beginning of this manual must be followed at all times when using
this product.
Follow the instructions below in order to switch on the appliance:
4. Remove the product from its original packaging taking special care not to damage any of its parts. Do not
use excessive force to remove the product from the box.
5. Switch on the appliance by selecting from the three speed settings (C)
6. Adjust the temperature using the thermostat control (D). The unit will be turned off automatically once
2,25m
0,6m
2,4m
13