Specifications - Sharp Plasmacluster IG-CL15U Manual De Operación

SPECIFICATIONS

Model
Power Supply
Fan Speed
Power Consumption(W)
Airflow Volume(CFM)
Applicable Floor Area(sq.ft)
Ion Density(ions/cm
3
Cord Length(ft)
Outer Dimensions(in.)
Weight(lbs)
* The applicable floor area for which an emitted airborne ion density of about 25,000 ions/cm 3 can be
measured at a point near the center of the room (at a height of about 1.2m from the floor), during operation
at the HIGH mode when the main unit is placed near a wall. Louvers adjusted to their lowest tilt angle.
*2 Ion count per cm 3 blown into air at around the center of the room (at a height of about 1.2m from the floor)
during operation at each airstream setting when the main unit is placed near the wall. Louvers adjusted to
their lowest tilt angle.
• The number of ions will vary according to the room conditions and operation mode.
Standby Power
In order to operate the electrical circuits while the power plug is inserted in the wall socket, this
product consumes about 0.4W of standby power.
For energy conservation, unplug the power cord when the unit is not in use.
TROUBLESHOOTING
Before calling for service, please review the TROUBLESHOOTING chart below.
The problem may not be a unit malfunction.
Problem
The Plasmacluster Ion Generator
does not work.
Flashing (red)
Flashing (orange)
Flashing (blue)
Lighting (orange)
Flashing (blue)
Flashing (red)
Flashing (orange)
*
)
*2
IG-CL5U
20V,60Hz
HIGH
7
46 ( .3m /min )
3
6 ( 5m
25,000
6.5 ( 2.0m )
( W ) x6
 /
0
2
7.3 ( 3.3kg )
WHAT TO DO
• Make sure to insert the plug.
• Attach filter properly. (See page E-11)
• It's time to replace Plasmacluster Ion Generating Unit.
Replace with a new Plasmacluster Ion
Generating Unit. (See page E-)
• Plasmacluster Ions are not released. Dust may block the filter,
clean the filter. (See page E-9)
• Remove dust from the needle electrode. (See page E-0)
If the lights are still flashing after cleaning filter, unplug and
contact the store you purchased or Sharp service center.
• Filter is getting dirty. Clean the filter.
After cleaning the filter, press Filter Reset
Button for 3 seconds. (See page E-9)
• Confirm the Plasmacluster Ion Generating Unit is set in
correct position. (See page E-)
• Failure
Unplug the power cord and contact the store you
purchased or Sharp service center.
E-2
LOW
3
30 ( 0.8m /min )
3
)
2
7,000
( D ) x3 ( H )
 /
8