Getting Started; Power On/Power Off; Reset Device - Trevi Sound Pad 360 Manual Del Usario

Sound
Pad 360

GETTING STARTED

Power on/Power off

Long press the Power button (8) for 4 seconds to power on the device. It will take about
a minute and half to boot the system.
Unlock the screen by sliding upwards.
To power off the device
Long press the Power button (8) for 4 seconds to power off the device. The screen will
show the power off options: Power off or Reboot.
Note
When the device is low battery, it will alert continuously and will shut down automatically when
battery has completely run out. The device cannot be powered on if the battery is empty, please
recharge the battery at least one minute before restart the device.
Standby and Lock screen
Press the Power button (8) shortly to turn the device to standby mode. Under standby
mode, the screen is blackout and volume is muted. Press the Power button (8) shortly
again to reactivate the device. The device will then turn to Lock screen while the primary
operation of the device will continue.
Unlock the screen by sliding upwards to resume to status before power saving.
Note
The primary operation of the device under standby mode will pause and the primary operation of
the device under Lock screen mode will continue, only the screen is locked.

Reset device

Press the Power button (8) for 10 seconds to reset the device in case of malfunction.
Change the Home screen
To change the display of the Home screen from the one of the factory to the classic of
Android, press the SWITCH button (7) on the remote control.
25