Publicidad
STEP 7 : INSTALLING DRAWER
TILT DRAWER AT AN ANGLE. PLACE WHEEL ON DRAWER
OVER WHEEL ON RUNNER AND SLIDE DRAWER INTO
PLACE.
IF DRAWER ALIGNMENT NEEDS TO BE ADJUSTED, FOLLOW
THESE STEPS.
1. REMOVE DRAWER
2. LOOSEN FRONT SCREW ON LEFT OR RIGHT SIDE
PANEL
3. MOVE DRAWER RUNNER UP OR DOWN AS REQUIRED,
TIGHTEN SCREW.
4. GENTLY PUT DRAWER BACK IN IF ALIGNMENT IS OK
IMPORTANT :
- YOUNG CHILDREN MAY BE INJURED BY TIPPING OF THE FURNITURE, AND THE USE OF FURNITURE TIPPING
RESTRAINT IS HIGHLY RECOMMENDED FOR PROTECTION AGAINST THE UNEXPECTED TIPPING OF FURNITURE
DUE TO IMPROPER USE.
- READ INSTALLATION INSTRUCTIONS BELOW AND ON PLASTIC PACK.
FURNITURE TIPPING RESTRAINT INSTALLATION INSTRUCTIONS :
1.
ATTACH ONE OF THE MOUNTING BRACKETS SECURELY TO THE BACK
EDGE OF THE FURNITURE. USE THE SHORTER SCREWS.
2.
DETERMINE WHERE FURNITURE IS TO BE PLACED AND MARK
LOCATION ON THE WALL FOR THE MOUNTING BRACKET SCREW
HOLE APPROXIMATELY 2” BELOW THE BRACKET MOUNTED TO THE
EDGE OF THE FURNITURE.
3.
DRILL A 3/16” HOLE IN THE WALL. PRESS THE PLASTIC ANCHOR
INTO THE HOLE AND GENTLY TAP UNTIL THE FLANGE ON THE
ANCHOR IS AGAINST THE WALL SURFACE.
4.
POSITION THE BRACKET OF THE ANCHOR AND USE THE LONGER
SCREW TO SECURELY ATTACH THE BRACKET TO THE WALL.
5.
PLACE THE FURNITURE SO THE BRACKET ON THE BACK EDGE IS IN
LINE WITH THE BRACKET ON THE WALL.
6.
LACE AN END OF THE NYLON RESTRAINT STRAP DOWN THROUGH
EACH BRACKET. BRING BOTH ENDS TOGETHER AND SLIDE
BEADED END OF THE STRAP THROUGH THE KEYHOLE SHAPED SLOT
IN THE OTHER END UNTIL SNUG. PULL DOWN ON THE BEADED END
UNTIL IT SNAP LOCKS INTO THE KEYHOLE SLOT.
7.
TO DOUBLE LOCK, RETURN THE BEADED END BACK THROUGH THE
KEYHOLE AS SHOWN.
8.
CHECK TO MAKE SURE THE STRAP IS SECURELY LACED AND LOCKED
TO THE BRACKETS.
BRACKET INTO
THE
THE UNIT
WALL
PLASTIC
ANCHOR
2 “
BRACKET INTO
THE WALL
Publicidad
