Using Lighting Node Pro; Frequently Asked Questions - Corsair Carbide Serie Guia De Instalacion

CARBIDE SERIES
®

9. Using Lighting Node PRO

• Turn your system off prior to installing your Lighting Node PRO.
• Plug the mini USB cable into the back of the Lighting Node PRO
then plug the 9-pin end into an available internal USB 2.0 header in
your system.
• Connection Notes
> The Fan LED wiring must be connected to the fan hub in the order
you want the lighting effects to be displayed.
> Fans must start at "1" and continue in series. 1 > 2 > 3 > 4 > 5 > 6
> Any fan not connected in series will break communication and the
RGB LED lighting function will not work.
• Mount the fan(s) to the location of your choice in the chassis.
• Find a location for the fan hub that allows connection for all of the
fans RGB LED cables installed in your system to reach.
> The fan controller will also need to be plugged into the fan hub for
control of the RGB LED lighting.
• Mount the fan hub with the provided mounting strips.
9
SPEC-OMEGA RGB

Frequently asked Questions

1. Does the polarity matter with the I/O panel's power and
reset header?
No, only the LED headers.
2. Who should I contact if I received my case damaged or one of the
fans is no longer working?
Please go to www.corsair.force.com and request an RMA
so that we can replace the damaged part(s).
3. Where can I mount a fan?
Fan Mount Locations
Front
Top
Rear
To learn more about this case visit the product page at corsair.com
3x 120mm / 2x 140mm
2x 120mm/140mm
1x 120mm
10