Introduction; Safety Instructions - Rohde & Schwarz Hameg HZ56-2 Manual

Introduction

The HZ56-2 AC/DC Current Clamp has been designed for
use with oscilloscopes and DMMs for accurate, non-intru-
sive measurement of both AC, DC, and complex waveform
currents. Using advanced Hall Effect technology the HZ56-2
can accurately measure currents with a resolution of 1 mA
from 5 mA to 30 A over the frequency range of DC to 100 kHz.
These features make it a powerful tool for use in inverters,
switch mode power supplies, industrial controllers and other
applications requiring current measurements and/or wave-
form analysis.

Safety Instructions

Please read this section carefully. It will make you familiar
with the most important safety instructions for handling your
product. In this instruction sheet, a Warning identifi es condi-
tions and actions that pose hazard(s) to the user. A Caution
identifi es conditions and actions that may damage the calib-
rator or the test instruments.
Warning
The HZ56-2 may only be used and handled by qua-
lifi ed personnel. To avoid personal injury, follow
these precautions:
Symbol
12
Subject to change without notice
Do not dispose of this product as unsorted municipal
Do not dispose of this product as unsorted municipal
waste. Contact HAMEG Instruments GmbH or a
waste. Contact Fluke or a qualified recycler for
qualifi ed recycler for disposal.
disposal.
Important Information. See manual.
Double insulation.
Do not apply around or remove from the HAZARDOUS
LIVE conductors.
Conforms to Canadian Standards Association.
Complies with the relevant European standards.
Description