Front Panel - Intellinet 561280 Manual Del Usario

English
The Intellinet 24-Port Gigabit Ethernet Switch with 10 GbE Uplink offers an array of features while providing superior
network throughput.
Equipped with 24 auto-sensing 10/100/1000 Mbps RJ45 Gigabit Ethernet ports, this switch offers plenty of
performance for your computers, servers and other networking devices. In addition, two 10 GbE small-form-factor
pluggable GBIC module slots (SFP+) provide fiber connectivity for greater distances. These are not shared combo-
ports, but true 10 Gigabit ports, pushing the total available bandwidth up to 88 Gbps.
Equipped with two 10 GbE SFP+ open slots, the Intellinet 24-Port Gigabit Ethernet Switch is the ideal solution for cost-
sensitive organizations considering 10 Gigabit Ethernet. With 10 GbE technology going mainstream and becoming
ever more popular, the need for additional bandwidth has become more urgent than ever before — even in smaller
networks. Whether you wish to connect servers, network attached storage units or NVRs at 10 Gbps, or perhaps you
simply want to connect to another Gigabit switch without resorting to LACP techniques, 10 GbE provides the solution.
This guide presents the basic steps to set up and operate this device. For detailed instructions and
specifications, refer to the user manual enclosed with this product or at intellinetnetwork.com.

Front Panel

LED
Power
1~24
Link/Act/Speed
25~26
Link/Act
SWITCH
Flow Control
Trunk
2
COLOR STATUS
Green
Orange
(10/100 Mbps)
Green
(1000 Mbps)
Flashing
1 G
(1 Gbps)
10 G
(10 Gbps)
Flashing
STATUS
On
Off
Activate trunking for ports 25 and 26 for a combined throughput of
40 Gbps in full-duplex mode. When activated, ports 25 and 26 operate
On
as one logical unit. They must be connected to equally trunked ports
Deactivate trunking for ports 25 and 26, so that they operate as
Off
24-Port Gigabit Ethernet Switch with 10 GbE Uplink
On
Off
On A device is connected to the port
Off A device is disconnected from the port
On A device is connected to the port
Off A device is disconnected from the port
OPERATION
Activate IEEE 802.3x flow control.
Deactivate IEEE 802.3x flow control.
on the other end.
individual ports (default).
STATUS DESCRIPTION
Power On
Power Off
Sending or receiving data
Sending or receiving data