General Operation - auna Areal Bar 700 Manual Del Usario

Connecting mains power
Connect the attached mains plug to a mains power supply outlet. Switch the power outlet ON.
Standby Mode
• Press the STANDBY button (U2 Unit & R3 Remote). to wake the unit from STANDBY mode.
• To enter STANDBY mode press either STANDBY buttons (U2 Unit & R3 Remote).
• NOTE: As part of the power saving mode the unit will enter STANDBY mode automatically after 10
minutes (approx) of no audio output.
Playing audio from a connected TV or other devices
After connecting a TV or other device to the Sound bar, follow the below steps.
• Ensure the Sound bar is powered ON. If not press the STANDBY button (U2) or remote (R3).
• Press the SOURCE button (U3,R2) repeatedly to choose the correct source to play. The source icon will
appear on the display.
• Adjust the output volume using the VOLUME +/- buttons (U6 Unit or R5 Remote).
Digital Audio Connections: Please note when connecting the soundbar using DIGITAL cables (COAXI-
AL or OPTICAL), the AUDIO SOURCE MUST be set to output PCM digital audio.
Adjusting the Sound
• Press VOL+/- to adjust the output volume level.
• Press AUDIO MODE (on the RC) repeatedly, to select from the available audio modes STANDARD,
MOVIE, MUSIC or NEWS.
• Press B+/- to adjust the bass level.
• Press mute to mute the output. Press again to un-mute.
22
Operation

General Operation