Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6
Safety Notes
6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The hot and cold supplies must be of equal
pressures.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• Prior to installation, inspect the product for transport
damages.
After it has been installed, no transport or surface
damage will be honoured.
• The fittings must be mounted in an insulated manner
and with sound insulation.
Assembly
Mount the body in such a way, that the outlet faces to
the top and that the marking on the protective cover is
flush with the face of the tiling.
Depth of fitting 55 - 83 mm.
Extension set 28 mm.
Note: When installation is complete ensure
that the mixer is turned off!
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Connections G 1/2:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
The product is exclusively designed for drinking water!
4
English
Symbol description
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
cold right - hot left
Adjustment
To adjust the hot water limiter on single lever
mixers, please see page 33. No adjustment
is necessary when using a continuous flow
water heater.
Dimensions (see page 31)
Flow diagram (see page 31)
Spare parts (see page 32)
Final assembly (see page 34)
Special accessories
extension set 28 mm (32698000) order as
an extra
Test certificate (see page 36)
Publicidad
Tabla de contenido
