Defy Ultraderm Therapy Manual De Instrucciones página 3

Deep Cleanse Mode: Two to three times weekly
steP 1
Deep Cleanse Mode cleans the skin by using the oscillation of the metal
tip to remove dead skin cells, oils, and other impurities from the pores.
The Defy Ultraderm Therapy device requires a medium in order to work.
Lather water and Defy One Step Cleanser in hands and apply to face
before treating. Make sure the surface being treated is continually moist.
steP 2
1. Plug the adapter into the slot located at the base of the unit, then
plug the adapter into the power outlet.
2. Press the power button to turn the device on to Mode 1—Deep
Cleanse Mode. The Clean indicator light should illuminate.
steP 3
1. Hold the device at a 45-degree angle to the skin with the angled part
of the metal tip pointing down.
2. Glide the tip gently forward along the skin (refer to the diagram
above). Do not use on the eyelids or thyroid gland (at front of neck).
3. Glide in a forward direction only, not back and forth.
4. Reapply water as needed to ensure the treated area remains moist.
Repeat this step at least twice. More passes are necessary if the surface
is oily or congested. Wipe the blade tip with a cloth or tissue to remove
the impurities that come out of the skin. The process usually takes 3 to 5
minutes for a facial treatment.
2
steP 4
After completing the Deep Cleanse Mode, rinse your face with water,
pat dry, and apply Defy Triple Action Toner.
Permeate Mode: Once daily
steP 1
Permeate Mode infuses product into the skin using mechanical heat
and sonophoresis.
Spread a layer of Defy Age Erasing Serum on the skin—do not
rub it in. If the Defy Triple Action Toner dries too quickly during
the treatment, either spray the skin with water or apply a layer of
moisturizer (such as the Defy Face Lifting Night Cream) over it to
keep the skin continually moist.
steP 2
To select Permeate Mode, press the power button twice. The
Permeate indicator light should illuminate.
steP 3
1. Hold the device so that power buttons are facing the skin and the
device is at a 30-degree angle. The angled end of the metal tip
should be in contact with the skin.
2. Glide the flat tip over the skin in a backward motion.
3. Keep your skin moist.
3