Defy Microderm Treatment Manual De Instrucciones página 4

1. Push disc tightly onto the metal tip at the end of the device. (To
remove a disc, just pull off.)
2. Place the properly-sized cap over the disc. Screw until tight. The seal
must be tight to ensure proper suction from the vacuum.
3. Plug cord into the device and twist ¼ turn to secure. Plug the cord
into a power outlet.
Remember not to operate this device without the plastic safety cap
securely in place. The top of the disc should be just barely below the top
of the cap so that the vacuum can suck the skin to the disc.
steP 2: PreParation
1. Cleanse and dry the desired treatment area, removing all dirt, makeup,
and oil. Skin must be dry, not wet or damp, when using the device.
2. Make sure hair is pulled back and all facial accessories are removed.
steP 3: treatment
1. Using the fingers of your free hand, stretch the skin to create a
smooth surface where the tip will make contact.
2. Turn the device on. Ensure that the cap is flush with the skin as you
make contact. The motor sound will change when suction occurs.
3. Move the disc in upward and horizontal motions until you have treated
all of the desired area.
4. Keep the tip moving constantly over skin surface—do not hover in one spot.
5. Use light pressure with early treatments, starting with one pass of
2