Hardware Installation - Conceptronic CMULTIFP2 Guía De Iniciación Rápida

ENGLISH

2. Hardware installation

1. Power the computer off, remove the power cable.
2. Remove the computer casing.
3. Remove the cover of a free 5.25 front of your computer.
Bundle all the cables including the bracket(s) and slide them from to
front of the computer into the computer.
4. Remove two blind plates at the back for the cables.
5. When done, fasten the bracket(s) with a screw.
6. Close the computer casing.
7. Connect the external cables to your computer:
a. The USB 2.0 cables to free USB 2.0 or 1.1 connectors.
b. Firewire cable to a free Firewire connector. (when available)
c. Audio cables to the input/output of your soundcard.
d. S-video to a S-video connector of the Video OUT of the video
card (when available)
e. Composite cable to free composite connector of your video card a
(when available)
8. Power on the computer and continue to the driver installation.
Reference picture how to connect the cables to the
back of the computer.
(In this example only the USB cables (1,2) and
audio connectors (3) are connected)
8