Ingersoll Rand DB9-EU Serie Manual De Instrucciones página 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable
positions may be harmful to
your hands and arms. Stop
using any tool if discomfort,
tingling feeling or pain occurs.
Seek medical advice before re-
suming use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
•
When wearing gloves and operating models with
inside trigger, always be sure that the gloves will not
prevent the trigger from being released.
•
Wear safety shoes, hard hat, safety goggles, gloves,
dustmask and any other appropriate protective
clothing while operating the tool.
•
Do not indulge in horseplay. Distraction can cause
accidents.
•
Keep hands and fingers away from the throttle
lever until it is time to operate the tool.
•
Never rest the tool or chisel on your foot.
•
Never point the tool at anyone.
•
Compressed air is dangerous. Never point an air
hose at yourself or co–workers.
•
Never blow clothes free of dust with compressed air.
•
Be sure all hose connections are tight. A loose hose
not only leaks but can come completely off the tool
and while whipping under pressure, can injure the
operator and others in the area. Attach safety
cables to all hoses to prevent injury in case a hose is
accidentally broken.
•
Always blow out the air line before connecting to
the tool to clear the line of dirt.
Compressed air is dangerous. When blowing the
line clear of dirt, wear eye protection and keep the
air line directed towards a safe, clear area.
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620kPa)
DB9–EU/DT9–EU SPECIFIC WARNINGS
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by
the hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
•
Never disconnect a pressurized air hose. Always
turn off the air supply and bleed the tool before
disconnecting a hose.
•
The operator must keep limbs and body clear of the
chisel. If a chisel breaks, the tool with the broken
chisel projecting from the tool will suddenly surge
forward.
•
Do not ride the tool with one leg over the handle.
Injury can result if the chisel breaks while riding
the tool.
•
Know what is underneath the material being
worked. Be alert for hidden water, gas, sewer,
telephone or electric lines.
•
Use only proper cleaning solvents to clean parts.
Use only cleaning solvents which meet current
safety and health standards. Use cleaning solvents
in a well ventilated area.
•
Do not flush the tool or clean any parts with diesel
fuel. Diesel fuel residue will ignite in the tool when
the tool is operated, causing damage to internal
parts.
•
When using models with outside triggers or throttle
levers, take care when setting the tool down to
prevent accidental operation.
•
Do not operate the tool with broken or damaged
parts.
•
Never start the tool when it is lying on the ground.
•
Never drag the tool on the ground. The air port
and other openings will become clogged with dirt
and debris.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before instal-
ling, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________