Maintenance And Cleaning; Technical Specifications - Mestra R-100275 Manual Del Usuario

INTRODUCTION
The static steam jet cleaner R-100275 is
apractical tool designed
materials. A powerful steam jet at 110 ºC will
clean the elements in a quick and simple way.
The warm-up lasts scarcely 1 minute. It is
factory supplied with a cleaning basket, a cup to
measure the refilling water, and a pair of clamps
to hold small elements.
Read this manual carefully. It contains very
•
important information
installation, operation and maintenance of
the machine.
Store this manual in a suitable place for
•
further consultation.
Check the general state of the machine after
•
removing the packing.
Before connecting the unit, make sure the
•
voltage in the identification plate matches
the power source to be used. During the
installation all the safety requirements must
be observed and the instructions of the
manufacturer followed.
The manufacturer will not be liable for the
•
damage caused
grounding system.
Damage caused by incorrect installation or
•
operation of the machine will not be covered
by the warranty.
If in doubt, do not start the machine. Contact
•
a qualified and authorised technician.
INSTALLATION
Remove the packing and check the good
•
state of the machine and with all the
accessories (cup, basket and tweezers).
Choose a flat, horizontal and firm surface to
•
place the unit, away from heat and vibration
sources, and from inflammable materials.
Do not connect the unit, it would start
•
inmediatly.
OPERATION
Open the lid and slowly pour destilated or
•
demineralized water. Use the supplied
measuring cup, filling only to the red Max Fill
to clean dental
about a safe
by an inappropriate
line. Overfilling will cause the unit to spew
out hot water and steam.
Close the lid.
•
Connect the unit to a 230 V, 50/60 Hz power
•
source and switch it on. A red light will blink,
to indicate the water heating.
When the light is blue, it means that the unit
•
is ready to be used.
Place the pieces to clean in the basket on
•
the cup or hold them with the tweezers. For
best results, bring jewelry up to nozzle tip
where steam temperature is hottest.
Apply steam with a gentle push to the
•
button. Plugging the button all the way down
will create excessive steam and will quickly
reduce the steam pressure.
When steam stops flowing it is an inication
•
that the water tank is empty. Unit must
remain OFF –unplugged– for a minimum of
30 minutes before refilling the tank. NEVER
FILL THE TANK WHEN IT IS HOT.
Clean your jewelry in 20 seconds intervals,
•
allowing 5-10 seconds between the intervals
for pressure to build.
Switch the unit off immediately after use
•
– unit is NEVER meant to remain on.

MAINTENANCE AND CLEANING

In order to ensure a long working life and an
optimal operation we strongly recommend:
• Use destilated or demiralized water.
• To clean the tank, use a 50 % mixture of
distilled water an vinegar and soak for 5
minutes.

TECHNICAL SPECIFICATIONS

Voltage:
Power:
Height:
Width:
Depth:
Tank capacity:
Weight:
Steam temperature:
English
230 V, 50/60 Hz
1100 W
260 mm
165 mm
250 mm
190 ml
1650 gr
110 ºC
7