Using The Battery - Signal ON GO 8000mAh Guía Del Usario

NOTE: Only charge OnGo with the included AC adapter
TO CHECK BATTERY CHARGE STATUS
1. Short press the POWER button (do not hold it down).
2. The Green LED lights will light up according to how much battery life remains;
NOTE: 1 LED = 0 - 25%, 2 LEDs = 25% - 50%,
3 LEDs = 50% -75% and 4 LEDs = 75% -100%.

USING THE BATTERY

1. Turn ON OnGo by holding down the POWER button for 3 seconds.
2. Plug the device into one of the USB ports.
NOTE: If available, using the original USB charge cable that came with your device is
recommended.
3. To turn OFF the battery, hold down the POWER button again for 3 seconds. This will prolong
the life of your battery when not in use.
DC IN