Mounting Bracket To Cabinet Wall; Tubing Connections - GEA GN1S04C Manual Del Propietario E Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

www.DiscountFilterStore.com

Mounting Bracket to Cabinet Wall

The bracket can be used as a template for marking the location of the
mounting screws. When determining the location of the bracket make sure
you leave 1-1 ⁄ 2 " to 2" of free area under the sumps to allow for sump removal
and enough space on either side to make the tubing connections.
Tubing Connections—Compression Style
(Models GX1S04C and GN1S04C)
Run the length of 3⁄8" tubing, connected to the bottom of faucet, to the
1
filter system outlet. Allow enough slack in the tubing so the unit can be
easily removed for filter changes. Measure and cut the end of the tubing
square.
2
Slide a compression nut onto the end of the tubing and push a tubing
insert into the tubing.
Connect the tubing and tighten the compression nuts securely.
3
Repeat the preceding steps to connect a length of tubing between the filter
4
system inlet and the water supply/saddle valve (illustration in the
Installation Overview section).
Tubing Connections—Push-In Style (Model GX1S15C)
1
Run the length of the 3⁄8" tubing, connected to the bottom of the faucet,
to the filter system outlet (illustration above). Allow enough slack in the
tubing so that the unit can be easily removed.
2
Measure and cut the end of the tubing square using a sharp cutter or knife.
Remove any burrs (illustration A).
Inspect the end of the tubing, about 1 inch, to be sure there are no
3
imperfections. It may be necessary to cut the tubing again.
Mark the tubing for length of insertion. For 3/8" OD tubing the insertion
4
length should be approximately 3/4 of an inch. Tubing must be fully
inserted to avoid leaks.
DO NOT REMOVE GRAY COLLET. Push the tubing all the way into the fitting
5
until it bottoms out. The insertion line should be hidden or barely visible
(illustration B and C). Slightly pull on the tubing to verify engagement.
Repeat the procedure to connect the tubing between the filter system
6
inlet and the water supply/saddle valve (illustration in the Installation
Overview section).
To remove tubing (illustration D), depress and hold gray collet.
7
Pull tubing to remove.
NOTE: Avoid installing the unit where the tubing is pulled at a sharp angle.
This type of installation may cause the fittings to leak. If using tubing other
than what is supplied, be sure it is high quality, exact size and roundness, and
has a smooth surface.
support@discountfilterstore.com
support@discountfilterstore.com
2-3⁄4"
Mounting
bracket
Tubing connector
(inlet)
Sump
1-1⁄2" to 2"
Cut tubing square
A
End of tubing round and smooth, with no cuts,
nicks or flat spots (approximately 1")
Gray Collet
B
(DO NOT REMOVE)
Insertion line
Tubing
3⁄4"
Insert
Gray Collet
C
(DO NOT
REMOVE)
Insertion line
Insert tubing
Engagement
3/4" (3/8" tubing)
Gray Collet
D
Tubing
www.DiscountFilterStore.com
Tubing connector
(outlet)
Mounting
screws
Tubing must
be fully inserted
to avoid leaks.
3
"
4
Depress gray collet
and pull tubing
to remove
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gx1s04cGx1s15c

Tabla de contenido